Dreame X40 Ultra Manual Del Usuario página 12

Routine Maintenance
EN
Washboard Base
The base station will perform washboard self-cleaning along with each mop
pad cleaning. For deep cleaning, please refer to the following steps.
1. Enable the washboard base cleaning function in the app, and the robot
will exit the base station automatically. Take out the washboard and wait for
water to fill the washboard base.
2. Use the cleaning tool to clean the washboard base. After a moment, the
base station will automatically pump out the used water. Then wipe the
washboard base with a soft and dry cloth.
18
3. Flip the washboard over, remove the roller cover and the roller in turn, and
then pull off the end caps of the roller.
Wipers
Note: If the roller cover is blocked by wipers on both sides of the washboard,
rotate the roller to move them aside.
4. Remove the hair tangled in the roller, and then reassemble the parts
according to corresponding colors, as shown in the figure below.
Routine Maintenance
5. Rinse the washboard with clean water, wipe it clean and then put it back
into the base station downwards in an inclined way.
6. Use the app or briefly press the button on the robot to make it return
to the base station.
Note: During cleaning, do not make the robot return to the base station.
Used Water Tank
1. Remove the used water tank, open its cover and pour out the used water.
2. Rinse the used water tank with clean water, and use the provided
cleaning tool to clean the inner wall of the used water tank.
Note: The float ball in the used water tank is a movable part. Do not apply
too much force when cleaning it to avoid damaging it.
EN
19