Publicidad
Idiomas disponibles
Idiomas disponibles
• Before serving Cold Brew drinks, empty out the water
tank, rinse thoroughly and refill with fresh potable
water.
• When making Cold Brew drinks after hot preparations,
the machine recommends a cold rinse to optimize the
temperature of the drink. In this case, proceed making
the rinse in a container or skip the tip.
Other cold coffee drinks: Set the parameters, then press
"Start" and proceed as follows:
• Select whether to make an "Ice" or "Extra Ice" drink, then
press "Next";
• Depending on the previous selection, before delivery,
the appliance suggests the quantity of ice cubes. Add
the quantity of ice cubes indicated to the glass (fig. 14),
then press "Brew".
• The appliance starts making the drink and a description
of each individual phase (grinding, brewing coffee) ap-
pears on the display.
3. At the end of delivery, press "Save" to save the new set-
tings, or "Cancel" to retain the previous parameters.
Please note:
If you save the new settings, they are memorized ONLY in the
selected profile.
4. Press "X" to go back to the homepage (C).
The appliance is ready to be used again.
9.4 Making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
•
Never use more than 1 level measure (D2) as it could soil
the inside of the coffee machine or block the funnel (A4).
When using pre-ground coffee, only one cup can be made at a
time.
Making Long coffee: halfway through preparation, when
•
requested by the appliance, add one level measure of pre-
ground coffee and press "OK".
You cannot make Doppio+, 2x Espresso, Coffee Pot, Cap-
•
puccino+ and Cold Brew drinks using pre-ground coffee.
1. Press
(C2) at the bottom of the image corresponding
to the coffee you want to make (e.g. espresso, fig. 15). The
parameters that can be customized according to taste ap-
pear on the display;
2. Select the quantity and pre-ground coffee
3. Press "Brew";
4. Lift the pre-ground coffee funnel lid, make sure the funnel
(A4) is not blocked, then add one level measure (D2) of
pre-ground coffee (fig. 16). Press "OK" to make the drink;
5. The appliance starts making the drink and a description of
each individual phase (grinding, brewing coffee) appears
on the display.
At the end of preparation, the appliance is ready to make the
next drink.
9.5 Bean Adapt Technology & Espresso SOUL
A coffee expert at your fingertips to help you optimize coffee
brewing and the result in your cup in just a few steps.
The smart technology guides you to adjust the machine accord-
ing to the coffee beans used - from grinding coarseness to brew-
ing, each phase will be regulated to get the best results from
the coffee bean.
Download and open the Coffee Link App to find out more.
Once the settings have been saved in the "Bean Adapt Technol-
ogy" section of the App, you can use the "Espresso SOUL" (C1)
drink on the homepage (C).
To make espresso coffee, follow the instructions in section "9.2
Directly selected drinks".
Please note:
You can modify the quantity of the "Espresso SOUL" drink as de-
scribed in section "9.3 Customizing the drinks".
9.6 General indications for making coffee drinks
•
A quantity of water above level 1 is sufficient to complete
most drinks. Always filling above level 1 allows the appli-
ance to estimate the amount of water available to make
the drinks.
•
While the machine is making the coffee, preparation can be
interrupted at any moment by pressing "Stop" or "Cancel".
•
As soon as delivery has ended, to increase the quantity
of coffee, just press "Extra". When the required quantity is
reached, press "Stop" or "Cancel".
•
Various alarm messages could be displayed while using
;
the appliance ("Please fill the tank with fresh water up to
MAX level" etc.). Their meaning is explained in section "22.
Displayed messages".
•
Cold Extraction Technology: for best results when
preparing Cold Brew drinks, fill the water tank with fresh
potable water.
14
16
Publicidad
