Publicidad
Idiomas disponibles
Idiomas disponibles
DISPLAYED MESSAGE
Water circuit empty. Press OK to
start filling process
The coffee beans profile has
changed! Remember to brew at
least 3 coffees before changing
the coffee beans profile
For an optimal temperature
Please start a quick rinse to cool
me down a bit. Place a 0,2L/
67.63 fl.oz container under the
spouts and press Start
For an optimal temperature
Please start a quick rinse to heat
me up a bit. Place a 0,2L/ 67.63
fl.oz
container under the spouts and
press Start
MEANING
The water circuit is empty
A new water softener filter has been
inserted (D4)
The appliance needs to brew at least 3 cof-
fees before Bean Adapt can be adjusted
You want to prepare a "cold brew technolo-
gy" drink after preparing several hot drinks.
You want to prepare a hot drink after pre-
paring "cold brew technology" drinks.
Energy saving is enabled.
The machine must be descaled.
The filter must be replaced (D4)
Remember to clean the milk carafe (E) or
(F).
The connection is configured in the appli-
ance settings menu (C3).
Indicates that the appliance is connected.
28
SOLUTION
Press "OK" to fill the circuit. Delivery stops au-
tomatically. It is normal for there to be water
in the drip tray (A15) after filling.
If the problem persists, make sure the water
tank (A23) is fully inserted.
Make sure you have followed the instructions
for inserting the new filter (sections "19.1
Installing the filter" and "19.2 Replacing or
removing the filter"). If the problem continues,
remove the filter (section "19.2 Replacing or
removing the filter").
Brew at least 3 coffees with the new coffee
before changing the Bean Adapt
Put a container under the coffee spouts and
press "Start" for a quick cold rinse to cool the
coffee circuit or press "Skip" to directly brew
the desired drink.
Put a container under the coffee spouts and
press "Start" for a quick hot rinse to heat the
coffee circuit up or press "Skip" to directly brew
the desired drink.
To disable energy saving, proceed as described
in section "7.9 General".
The descaling procedure described in section
"17. Descaling" needs to be performed.
Replace the filter or remove it as described in
section "19. Water softener filter".
Turn the froth adjustment dial (E3) or (F3) to
CLEAN.
Connect to the Coffee Link App.
To disable the connection, proceed as de-
scribed in section "7.3 Connectivity".
→
Publicidad
