Descargar Imprimir esta página

Husqvarna 965 96 07-01 Manual Del Usuario página 27

Publicidad

Idiomas disponibles

Idiomas disponibles

Bar groove width, in/mm. The groove width in guide
bar must be the same as the chain drive links width.
Chain oil hole and hole for chain tensioner. The
guide bar must align with product.
Drive link width, mm/in.
General information about how to sharpen the
cutters
Do not use a blunt saw chain. If the saw chain is blunt,
you must apply more pressure to push the guide bar
through the wood. If the saw chain is very blunt, there
will be no wood chips but sawdust.
A sharp saw chain eats through the wood and the wood
chips becomes long and thick.
The cutting tooth (A) and the depth gauge (B) together
makes the cutting part of the saw chain, the cutter. The
difference in height between the two gives the cutting
depth (depth gauge setting).
When you sharpen the cutter, think about the following:
1527 - 001 - 25.06.2020
A
B
Filing angle.
Cutting angle.
File position.
Round file diameter.
It is not easy to sharpen a saw chain correctly without
the correct equipment. Use Husqvarna file gauge. This
will help you to keep maximum cutting performance and
the kickback risk at a minimum.
WARNING: The force of the kickback
increases a lot if you do not follow the
sharpening instructions.
To sharpen the cutters on page 27 for
Note: Refer to
information about sharpening of the saw chain.
To sharpen the cutters
1. Use a round file and a file gauge to sharpen the
cutting teeth.
27

Publicidad

loading

Este manual también es adecuado para:

3120xp