BM2 BIEMMEDUE SIDRA Serie Manual De Instrucciones página 30

• The instructions given in the "use and maintenance manual" are
not scrupulously complied with;
The scheduled maintenance services are not carried out;
•
Lubricants other than those indicated are used;
•
Repairs or maintenance are carried out by unqualified personnel;
•
• Non-original spare parts are used;
Unsuitable work equipment is used.
•
WARNING
It is the Customer's responsibility to verify that only
original spare parts, which are the only parts that will not
compromise machine safety, are used for repairs.
When ordering spare parts, ensure that the machine model, the serial
number, the part reference number from the spare parts booklet and
the quantity are specified to the manufacturer.
9. MACHINE STORAGE CONDITIONS
9.1 MACHINE DECOMMISSIONING
If the machine will not be used for significant periods of time, it will
be sufficient to protect the raw parts (those not protected by paint,
surface treatments or plastics) with rust preventive oils. If the
machine is to be removed from service for a significant period of time,
it should also be thoroughly cleaned. Once these operations have
been completed, seal the machine inside an opaque multi-layer black
nylon bag where an appropriate desiccant (silica gel packets) has
been inserted beforehand.
10. DISPOSAL
10.1 MACHINE DISPOSAL
At the end of its working life, this machine is to be scrapped and
disposed of by handing it over to the local separate waste collection
system pursuant to and in scrupulous compliance with current
legislation. Before scrapping, check the machine's serial number
label. If the label bears this symbol
regulated by Legislative Decree no. 151 of 25/07/2005 and directive
2002/96/EC on Waste Electrical and Electronic Equipment (WAEE).
You should therefore become apprised of the local waste collection
system for electrical and electronic products and comply with its
requirements. Improperly disposing of this product as normal
municipal waste may result in serious harm to the environment and
human health, and may be subject to penalties from local authorities.
11. PERIODIC MAINTENANCE TABLE
PROCEDURE
Check operation of all
controls
Check the fittings gaskets
Check pump oil level
L-LC056.04-BM
, this means that disposal is
X
X
X X
EN
12. DEFECTS, CAUSES AND REMEDIES
The table below lists the defects that are most commonly found in
normal use of the high pressure washer. The causes of these
operating defects are easily solved with operations that fall within the
scope of ordinary maintenance. If the defect is not listed in the table
below or cannot be eliminated by following the recommendations
found herein, it is suggested that you contact a qualified and
authorized service centre.
DEFECT
The machine does
not start
Motor does not
start but makes
noise
Insufficient
pressure
Vibrations and/or
irregular water
output
Pump noisy
Milky oil
Water leaks
Water does not heat
or temperature too
low
CAUSE REMEDY
Power supply Check
interrupted or properties
insufficient
Circuit breakers Contact a service
tripped. centre
Insufficient Check
voltage properties
Nozzle fouled or Clean or replace
deformed
Valve fouled or Contact a service
worn centre
Pump is drawing Check
air fittings
Air in piping Purge
disconnecting
pipes
Pump seals Contact a service
worn centre
Delivery and Unscrew the valve
suction valves caps, remove them
blocked and clean them (it is
preferable
contact the service
centre)
Bearings worn Contact a service
centre
Water leaking Request
into the oil replacement
system from the
(emulsion) centre
Gaskets and/or Request
pistons worn replacement
from the
centre
No fuel oil Fill fuel tank
Fuel oil filter Inspect and clean
fouled
Photocell fouled Clean photocell
(model Plus)
Thermostat Request
malfunctioning replacement
Serpentine Request
fouled service
the line
the line
supply
by
the
to
the seal
pack
service
the seal
pack
service
technical
30 / 48