Steamfast NOMAD Guia Del Propietario página 4

HOW TO USE
FILLING TANK WITH WATER
1. Turn OFF (
) and unplug unit from power source.
2. Place steamer on its side on a flat, heat resistant, level surface.
CAUTION: If unit has been in use, allow to cool (5 minutes for minimum cooling before
removing Water Tank and adding water).
3. Remove Water Tank by pulling the Water Tank downwards away from the unit, see Figure 1.
4. Remove rubber cap from top of Water Tank and fill with distilled water from a bottle or cup.
Replace rubber cap on top of the Water Tank. Do not overfill Water Tank.
NOTE: In order to extend the life of your unit and keep it functioning at its maximum
potential, it is highly recommended that distilled water be used in Water Tank.
CAUTION: Burn Hazard. Using tap water could result in mineral buildup which could
block the steam outlets, causing this unit to spit or spurt hot water. Follow cleaning
instructions provided.
5. Replace Water Tank by pushing firmly up into the unit.
Always place steamer securely on the side when not in use. Do not rest steamer on other
surfaces or attempt to stand steamer on the Steam Nozzle or Base.
WARNING - Take care to not pinch your fingers or hand when replacing water tank into unit.
6
| ENGLISH
FIGURE 1
FABRIC STEAMING
CAUTION: When steaming any material for the first time, it is recommended that you test
on a small inconspicuous area before proceeding. Do not use on synthetic fabrics such as
100% nylon or polyester, or other steam-sensitive materials.
NOTE: Be sure the Water Tank has already been filled before following these steps.
1. Plug power cord into a standard electrical outlet.
2. Power on and wait approximately 30 seconds until the Steam Status Light turns from red to
green, indicating the unit is ready to use.
3. Direct Steam Nozzle towards fabric material you wish to steam. See below for additional tips
and procedures.
WARNING: Always be sure that Steam Nozzle is pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
STEAMING GARMENTS:
• Hang garment from a clean, rust-free hanger.
• Direct Steam Nozzle towards bottom of garment. Steam will rise along inside and outside
of material, removing wrinkles. Slowly slide Steam Nozzle upward from bottom to top
of garment.
• Direct Steam Nozzle away from garment and smooth material with your free hand.
• Repeat as necessary until garment is fresh and wrinkle-free.
GENERAL STEAMING TIPS:
• For most effective results, hold Steam Nozzle within 1/2" of fabrics, or press it directly
against surfaces.
• Curtains and draperies can be steamed while still hanging.
• To remove wrinkles from towels, handkerchiefs and napkins, drape them over a rod or
towel rack and gently steam them.
• Heavier fabrics may require repeated steaming to achieve desired results.
• To remove exceptionally stubborn wrinkles, steam both sides of fabric.
• Be especially careful when steaming any delicate fabrics that may be damaged by heat or
water spotting.
When you are finished using your steamer, immediately turn off and unplug power cord from
electrical outlet. Refer to STORAGE & CARE for proper storage and maintenance procedures.
7
ENGLISH |