Warranty; Troubleshooting Guide - DeWalt DW703 Manual De Instrucciones

In addition to the warranty, D WALT tools are covered by
E
our:
1 YEAR FREE SERVICE
D WALT will maintain the tool and replace worn parts
E
caused by normal use, for free, any time during the first
year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of
your D WALT Power Tool, Laser, or Nailer for any reason,
E
you can return it within 90 days from the date of purchase
with a receipt for a full refund – no questions asked.
RECONDITIONED PRODUCT: Reconditioned product is
covered under the 1 Year Free Service Warranty. The 90
Day Money Back Guarantee and the Three Year Limited
Warranty do not apply to reconditioned product.
FREE WARNING LABEL REPLACEMENT: If your
warning labels become illegible or are missing, call
1-800-4-D WALT for a free replacement.
E
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! SAW WILL NOT START
WHAT'S WRONG?
1. Saw not plugged in
2. Fuse blown or circuit breaker tripped
3. Cord damaged
4. Brushes worn out
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT'S WRONG?
1. Dull blade
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being done
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT'S WRONG?
1. Extension cord too light or too long
2. Low house current
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT'S WRONG?
1. Saw not mounted securely to stand or work bench
2. Stand or bench on uneven floor
3. Damaged saw blade
TROUBLE! DOES NOT MAKE ACCURATE MITER CUTS
WHAT'S WRONG?
1. Miter scale not adjusted correctly
2. Blade is not square to fence
3. Blade is not perpendicular to table
4. Workpiece moving
TROUBLE! MATERIAL PINCHES BLADE
WHAT'S WRONG?
1. Cutting bowed material
14

Troubleshooting Guide

WHAT TO DO...
1. Plug in saw
2. Replace fuse or reset circuit breaker
3. Have cord replaced by authorized service center
4. Have brushes replaced by authorized service
center or replace them yourself as instructed
on page 8
WHAT TO DO...
1. Replace blade, see page 5
2. Turn blade around, see page 5
3. Remove blade and clean with turpentine and
coarse steel wool or household oven cleaner
4. Change the blade type, see page 5
WHAT TO DO...
1. Replace with adequate size cord, see page 1
2. Contact your electric company
WHAT TO DO...
1. Tighten all mounting hardware, see page 4
2. Reposition on flat level surface, see page 4
3. Replace blade, see page 5
WHAT TO DO...
1. Check and adjust, see page 6
2. Check and adjust, see page 6
3. Check and adjust fence, see page 6
4. Clamp workpiece securely to fence
WHAT TO DO...
1. Position bowed material as shown on page 13