Kärcher IVM 60/36-3 H Manual Del Usuario página 27

be disposed of in sealed bags in accord-
ance with the applicable regulations for
the disposal of this type of waste.
● The suction hose ports are to be closed
using the sealing plugs during transport
and maintenance of the device.
1. Note that you can carry out simple main-
tenance and care work yourself.
2. Clean the surface of the device and the
interior of the container regularly with a
moist cloth.
Inspection and maintenance work
Have the device regularly inspected ac-
cording to the respective national accident
prevention regulations. Maintenance work
as specified by the manufacturer must be
performed by a technically qualified person
at the specified regular intervals and in ac-
cordance with the applicable regulations
and safety requirements. Work on electrical
components may only be performed by a
qualified electrician. Please contact a
KÄRCHER branch office if you have any
questions.
Replacing the main filter
DANGER
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Accumulated dust must be transported in
dust-proof containers. Do not transfer the
contents. The dust bag may only be dis-
posed of by qualified staff.
WARNING
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Do not use the main filter element after re-
moving it from the device.
Permanently installed filters may only be
replaced by an expert in a suitable area,
e.g. a decontamination station.
1. Switch off the device.
2. Pull out the mains plug.
3. Unlock and remove the suction head.
4. Unlock and remove the spacer.
5. Remove the contaminated star pleated
filter.
6. Immediately after removing the contam-
inated star pleated filter from the unit,
place it in a bag and seal the bag tightly.
7. Dispose of the contaminated star pleat-
ed filter according to legal requirements.
8. Remove any dirt deposits from the clean
air side.
9. Check the sealing ring for damage.
10.Insert the new star pleated filter:
a Pull the new star pleated filter over the
filter vibrator on the spacer such that
the vibrating elements are aligned
centrally in the filter bags.
b Place the spacer with star pleated fil-
ter and filter vibrator on the filter ring.
c Lock the spacer.
11.Fit and lock the suction head.
Replacing the H filter
1. Secure the device with the parking
brakes.
2. Switch off the device at the power
switches.
3. Pull out the mains plug.
Illustration M
4. Unlock and lift the suction head.
5. Release the vacuum hose at the suction
head and remove the suction head.
6. Unscrew the hexagon screw anticlock-
wise using a suitable tool.
7. Remove the seals and the contaminated
H-filter from the suction head.
8. Immediately after removing the contam-
inated H-filter from the unit, place it in a
bag and seal the bag tightly.
9. Dispose of the contaminated H-filter ac-
cording to legal requirements.
10.Remove any dirt deposits from the clean
air side.
11.Fit the new H filter in the reverse order.
Make sure that the seals and the vacu-
um hose are correctly seated.
12.Apply a suitable agent (e.g. Loctite 243)
to the thread of the hexagon screw to
prevent unintentional loosening.
13.Tighten the hexagon screw clockwise.
14.Fit and lock the suction head.
English 27