Before First Use - Vollrath Stoelting Manual Del Operador

BEFORE FIRST USE

Turn on the Machine
1. Press the power button. Display shows
2. Press . The auger starts to rotate.
Set the Date
1. Press and hold .
2. Press to navigate to:
3. Press to select. The date format is DD/MM/YYYY.
4. Press or to change the date.
5. Press to move the cursor.
6. Press to save the date.
Set the Local Time
1. Press to navigate to:
2. Press to select. Time is displayed in a 24-hour format.
3. Press or to change the hour or minute.
4. Press to move the cursor.
5. Press to save the time.
®
Stoelting Mini Soft Serve Countertop Freezer Operator's Manual
Check the TLI Setting
The Temperature Limit Indicator (TLI) setting is the temperature to
which the machine will attempt to refrigerate the product. Compare the
TLI setting on the machine to the recommended temperature for the
mix you are using. If applicable, change the TLI.
NOTICE: The machine monitors torque and senses when the mix has
reached ideal serving temperature and may not continue to
refrigerate the product to a lower TLI setting. Therefore,
the display may show READY TO SERVE even though the
bowl temp is higher than the TLI setting. This feature helps
reduce the chance of an over-torque condition.
1. Press to navigate to:
2. Press to select.
3. Press or change to change the temperature.
4. Press to save the setting.
5. Press to exit.
Set the Default Temperature Mode (optional)
The machine will arrive set to display temperature in Fahrenheit. You
can change the default to Celsius.
1. Make sure the power is off.
2. Simultaneously press and hold
power button.
3. Hold for approximately 7 seconds until the temperature is
shown in Celsius.
4. Perform the procedure again to return the default to Fahrenheit.
Clean and Sanitize the Machine
Before you use the machine for the very first time, Vollrath
recommends washing and sanitizing the components in the machine.
1. Disassemble the machine. See page 6.
2. Clean and sanitize the components. See page 5.
3. Re-assemble and lubricate the components. See page 8.
4. Sanitize the machine. See page 4.
and press and release the
3