Audi 4M0.071.151 Instrucciones De Montaje página 29

4 Installing/removing the carrier
units and roof rack module
4.1 Installing/removing the carrier units
Note
◆ Prior to installation, check that you have all the components
from the scope of delivery.
◆ The carrier units must be installed by two people.
◆ Clean the contact areas and rubber supports thoroughly.
– A flap -X- is located on the upper surfaces of the left-hand
and right-hand roof rails at the same height as the B-pillar
and C-pillar. Each flap covers the mounting points used to
install the carrier units.
– To install the carrier units, the flaps -X- must be pressed
downwards at the front of each flap using a finger in the
-direction of arrow 1-.
– The flap -X- is pushed backwards and up in the
-direction of the arrow 2-.
Note
Prior to installation, the area around the flap -X- on the roof rails
and the rubber supports for the lower support bracket -3- must
be free of dust and grease.
Positioning the carrier units
– Plastic bars -D- are located on each lower support bracket
-3- of the carrier units for the purpose of correctly positioning
the carrier units through the holes in the roof rails.
Installation instructions - Audi Q7 (4M) 2016 ►
4 Installing/removing the carrier units and roof rack module
Edition 03/2015
9