Publicidad
Idiomas disponibles
Idiomas disponibles
– Use a hexagon key (M6) to unscrew the hexagon bolt -1- on
the right-hand support bracket far enough to allow the sup-
port bracket to be moved on the profile tube. The carrier unit
remains on the vehicle roof during this process.
– Adjust the carrier unit so that the rubber supports on the
right-hand support bracket sit flush with the roof rails -tick-.
– Tighten the hexagon bolt -1- to 10 Nm.
– Repeat the procedure on the other carrier unit.
– Place the profile cap back onto the profile tube.
WARNING
Check that all hexagon bolts have been tightened (to 10
Nm). If these guidelines are not observed, this can result
in the carrier units becoming loose or falling off – risk of
accident!
Installation instructions - Audi Q7 (4M) 2016 ►
4 Installing/removing the carrier units and roof rack module
Edition 03/2015
15
Publicidad
