Audi 4M0.071.151 Instrucciones De Montaje página 34

Installation instructions - Audi Q7 (4M) 2016 ►
Edition 03/2015
Caution
Do not use a high-pressure cleaner to clean the kayak hold-
ers.
4.4 Technical notes
Technical data
Dead weight of carrier unit set: approx. 5 kg (11 lbs.).
Roof load/load
Weight of the carrier unit
+ weight of the roof rack module
+ weight of the load
= roof load
WARNING
Never exceed:
◆ the maximum permissible roof load (100 kg/220 lbs.)
◆ the gross axle weight rating
◆ the gross vehicle weight rating for your vehicle
hicle Owner's Manual.
4.5 Adjusting the carrier unit width
Note
◆ Each carrier unit is pre-adjusted by the manufacturer in line
with your vehicle's requirements.
◆ If the carrier units are not correctly adjusted, the correct ba-
sic setting must be made by a qualified workshop.
Instructions for the qualified workshop if the position of the
support bracket for the relevant vehicle is not set correctly.
– Install the carrier units on the vehicle.
See chapter: 4.1. Installing/removing the carrier units
– Remove the profile cap -9- from the profile tube -2-.
14
4 Installing/removing the carrier units and roof rack module
⇒ Ve-