Publicidad
Idiomas disponibles
Idiomas disponibles
– Check the exact installation position of the carrier unit – the
plastic bar must be exactly aligned to the hole in the roof
rails. Move the carrier unit forwards or backwards if neces-
sary.
– Align the carrier units laterally – make sure that they sit cor-
rectly on the edge of the roof rails.
– If the rubber supports on the support bracket are not flush to
the surface, it is advisable to have the width adjustment of
the carrier unit checked and corrected by a qualified work-
shop.
See chapter: 4.5. Adjusting the carrier unit width.
– Remove the profile caps -9- from the profile tube -2-.
– Press down the tensioning bolts -4- by hand against the
spring and gently tighten.
– Place the torque wrench -5- onto each tensioning bolt -4-
and gently tighten.
Note
◆ Each tensioning bolt -4- must be gently tightened in the
same way on all support brackets of the carrier units.
◆ The tensioning bolts -4- must screw easily into the threaded
parts of the roof rails! If this is not the case, immediately re-
move the bolts to prevent damage to the threads of the ten-
sioning bolts and the threaded mating parts in the roof rails!
Installation instructions - Audi Q7 (4M) 2016 ►
4 Installing/removing the carrier units and roof rack module
Edition 03/2015
11
Publicidad
