Publicidad
Idiomas disponibles
Idiomas disponibles
– To install the roof rack modules, remove the profile cap -9-
from the profile tube -2-.
– Insert the roof rack modules into the T groove provided in
the profile tube -2- using the T groove adapter -A-.
– Place the profile cap -9- back onto the profile tube -2-.
Note
When the roof rack modules are not in use, seal the T groove
using the profile tube cover -1-.
– Adjust the profile tube cover -1- to the length of the carrier
units with the profile caps -9- closed.
– Place the profile covers -1- on the T groove on the carrier
unit -2- and press the covers into the T groove.
Note
◆ When driving with a roof load, make sure that the German
Road Traffic Regulations (StVZO) or any country-specific
regulations are observed.
◆ For reasons of convenience, it is common for the carrier
units with/without roof rack modules to remain on the vehi-
cle, even if they are not in use. Your vehicle will consume
more fuel due to increased wind resistance.
◆ It is advisable to remove a carrier unit after use.
◆ Additional wind noise can result from driving with a carrier
unit attached.
4.3
Maintenance instructions
Carrier units
The carrier units must always be cleaned and kept in good or-
der. It is particularly important to remove any dirt and salt in the
winter.
The carrier units can be cleaned using water.
Locks
The locks must be maintained after several locking cycles have
passed, and always after wet cleaning has been performed.
This process involves spraying the dust/dirt guard and the in-
side of the cylinder with an appropriate lubricant and then ac-
tuating the lock several times using the key.
WARNING
Do not use any lubricants on the bolted connections.
Failure to comply with these instructions may result in
the carrier units becoming detached, causing injury to
you or others and/or damage to property.
Installation instructions - Audi Q7 (4M) 2016 ►
4 Installing/removing the carrier units and roof rack module
Edition 03/2015
13
Publicidad
