Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Troubleshooting
Problem
Tool operating slowly
Tool seized
Tool will not stop after trigger is
fully released
12
Possible Cause
Pressure incorrect
Dirt within the mechanism
Air blockage
Air leak
Blockage in gauze mesh filter
Dirt or rust in mechanism
Dirt or rust in mechanism
Throttle valve O-ring or valve seat damaged
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Solution
Set the correct air pressure according to the specification
Pour oil into Air Inlet (4) as per maintenance instructions
Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by re-
tightening, using PTFE tape or replacing
Remove Quick Connector (5) and clean mesh filter
Try 'Tool operating slowly' solutions
Tap tool gently with a soft mallet
Have the tool repaired at an authorised Silverline service centre
Publicidad
