Bushnell TROPHY CAM HD ESSENTIAL Manual De Instrucciones página 16

Field Scan 2x with Live Trigger Feature
Field Scan is a revolutionary new feature for the Bushnell Trophy Cam HD
Essential E3, which allows you to monitor your food plots or field edges
with time lapse images or video. When set to "On", the Trophy Cam HD
Essential E3 will take a photo (or record a video clip) automatically at your
choice of intervals (for example, once every five minutes) during one or two
blocks of time you set up for each day, without requiring a trigger from
an active animal. This has the advantage of giving you the ability to monitor
the edge of a field that might be 50 or 150 yards away from the camera out
of the PIR sensor's range. The result is an effective range much greater than
it would normally be, with the camera dependant on triggers generated by
nearby animals. This is a great tool for hunters to scout an entire field with
only one camera.
If an animal does enter the area covered by the PIR sensor and generate a
trigger event during a time in between the Field Scan intervals you set, the
camera will capture an image or video just as it normally would, based on
your other menu settings. Here's how to setup and use Field Scan (be sure
you've set the current time in "Set Clock" first, so your Field Scan recording
will stop and start at the correct times of day):
1. Move the main switch to SETUP, then press MENU.
2. Keep pressing the RIGHT key, stepping through the Setup Menu until
you reach Field Scan.
3. Press the UP key to select On, and press OK (Step 1, pg.18). You will
see "A", representing the first block of time you can define (a second
block of time later in the day, "B" can also be setup if you wish). Press
OK (Step 2). This takes you to the screen to set Start and Stop times,
which determines the clock times when the first block of Field Scan
recording will begin and end for each day. You can set these times to
the exact hour and minute you want, for a recording "window" that
lasts anywhere from just a minute to a full 24 hours.
4. Set the [Start] and [Stop] times, beginning with the Start hour, using
the UP/DOWN keys to change the setting (Step 3). The hour setting
is based on a 24-hour clock, with "00" hours = midnight, "12" hours
= noon, "23" hrs = 11PM, etc. To move to the next setting, press the
RIGHT key, change the minute for the Start time with UP/DOWN,
then on to the hour and minute settings for the Stop time.
16