Correct Posture - Beurer BM 67 Manual De Instrucciones

The cuff must be placed on
the upper arm so that the
bottom edge is positioned
0.8 - 1.2 in (2-3 cm) above
the elbow and over the artery.
The line should point
to the centre of the palm.
Now tighten the free end of
the cuff, but make sure that it
is not too tight around the
arm and close the
hook-and-loop fastener. The
cuff should be fastened so that
two fingers fit under the cuff.
Now insert the cuff line into
the connection for the cuff
connector.
Blood pressure can vary be-
tween the right and left arm, which may mean that
the measured blood pressure values are different.
Always perform the measurement on the same arm.
If the values between the two arms are significantly
different, please consult your doctor to determine
which arm should be used for the measurement.
CAUTION:
Only use original Beurer cuffs with this device. The
included cuff is suitable for an arm circumference of
8.6 – 17.3 inches (22 – 44 cm). For larger arm circum-
ferences, contact customer service to order a lar-
ger cuff.

Correct Posture:

• Rest for at least five minutes before each meas-
urement.
• Perform the measurement either sitting or lying
down. Always make sure that the cuff is level with
your heart.
17