Care And Maintenance; Troubleshooting Guide - Beurer BM 67 Manual De Instrucciones

Copying Stored Measurements using
Bluetooth
®
1. Download and install the 'beurer HealthCoach'
app from your device's app store. Run the app and
make sure 'BM67' is selected under 'Settings/My
devices'.
2. Ensure Bluetooth
®
on the blood pressure monitor.
3. Access stored measurements on the unit as de-
scribed in the section 'Displaying and deleting
measurements'. Bluetooth
begin automatically if the two devices are paired
properly.
The 'beurer HealthCoach' app must be active to al-
low data transfer.
If your smartphone has a protective cover, remove
this to ensure that there is no interference during the
transfer.
We would explicitly draw attention to the fact that the
software to hand is not a medical product in accord-
ance with EU Directive 93/42/EEC. The values dis-
played are purely for visualisation purposes and must
is activated on your device and
data transfer should
®
not be used as a basis for therapeutic treatments. The
software is not part of a diagnostic-medical system.

10. Care and Maintenance

• Clean the device and cuff with a slightly moistened
cloth.
• Do not use detergents or solvents.
• Never immerse the device in water or other liquids.
• When storing the device, make sure no heavy ob-
jects are placed on top of it. Remove the batteries.
Ensure the Air Tube does not have any sharp kinks.

11. Troubleshooting Guide

In the event of errors, the error message
on the screen.
Error messages may appear if:
• It was not possible to correctly record the pulse:
• You speak or move during the measurement:
• The cuff is fastened too tightly or loosely:
• Errors occur during the measurement:
• The pump pressure is higher than 300 mmHg:
• The batteries are almost empty:
22
appears
;
;
;
;
4
;
4
;
4