Performing A Measurement - Beurer BM 67 Manual De Instrucciones

• To perform a measurement, sit comfortably with
your arms and back supported. Do not cross your
legs and place your feet flat on the floor.
• Keep still during the measurement and do not talk.
• Relax your arm and the palm of your hand.
Select a User Memory
This unit has four user numbers, each with 30 stor-
age slots each.
1. Press the SET Button and select a user memory
from 1 to 4 using the +/- Buttons.
2. Confirm by pressing the Start/Stop Button or just
wait for three seconds to set the user number.

Performing a Measurement

1. With the cuff attached properly and in a correct
posture, press the Start/Stop button
Display elements will briefly display and measure-
ment will begin after about three seconds. To can-
cel a measurement at any time, press the Start/
Stop Button .
2. As a measurement concludes, air pressure in the
Cuff will release. The pulse symbol ( ) will dis-
play, along with systolic and diastolic pressure.
The measurement data will be stored into the se-
lected user memory.
3. ' ' and a number from 1 to 7 will appear if the
measurement was not performed properly. Refer
to the 'Troubleshooting Guide' section for details
about specific error message numbers and repeat
the measurement.
4. Press the Start/Stop button
blood pressure monitor. The device will also shut
off by itself after about one minute.
5. Wait at least one minute before taking another
measurement.
. All LCD
18
to shut off the