Publicidad
Idiomas disponibles
Idiomas disponibles
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
Connectivity
This product is prepared for connectivity and has a
location for installation of a Husqvarna Connectivity
Device. When the Husqvarna connectivity device
is installed, the product has
technology and can use Husqvarna Fleet Services
connect to mobile devices. This enables more functions.
To install the Husqvarna connectivity device
Do the steps that follow to install the Husqvarna
connectivity device. For more information about
the Husqvarna connectivity device, refer to
www.husqvarna.com.
1. Remove the screw and open the plastic cover.
1679 - 005 - 02.11.2022
Husqvarna connectivity device
®
Bluetooth
wireless
™
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 30 for instructions.
9. Tighten the bar nuts.
Note:
Some models have only one bar nut.
2. Remove the connector.
to
3. Install the Husqvarna connectivity device.
To adjust the tension
11
Publicidad
