Skil SD561802 Manual Del Propietário página 21

NOTICE:
The tool will not operate when the trigger switch is
depressed during charging.
NOTICE:
The bottom of the tool may become warm during charging.
This is normal.
NOTICE:
Do not charge the tool in extremely hot or cold conditions.
Charging is best achieved at normal room temperature.
Fig. 2
(included with
some models)
Direction-of-Rotation (Forward/Center-Lock/Reverse)
Selector
WARNING
to help prevent accidental starting .
Your tool is equipped with a direction-of-rotation selector. This
selector is designed to change the direction of rotation of the bit
and to lock the trigger in the "OFF" (center-lock) position.
a) Position the direction-of-rotation selector to the right for forward
rotation.
b) Position the direction-of-rotation selector to the left for reverse
rotation.
c) Position the selector in the "OFF" (center-lock) position to help to
reduce the possibility of accidental starting when the tool is not in
use (Fig. 3).
After tool use, lock the direction-of-rotation
selector in the "OFF" position (center-lock)
21