contacts your eyes, flush them with water for a minimum of 10
minutes and seek medical attention.
Place power supply on flat nonflammable surfaces and away
from flammable materials when recharging battery pack.
Carpeting and other heat insulating surfaces block proper air
circulation which may cause overheating of the power supply and
battery pack. If smoke or melting of the power supply or battery
pack is observed, unplug the power supply immediately and do not
use the battery pack or power supply. Contact customer service
immediately.
Keep the cord and power supply from heat to prevent damage
to housing or internal parts .
Do not allow gasoline, oils, petroleum-based products, etc .
to come in contact with plastic parts . These materials contain
chemicals that can damage, weaken, or destroy plastic.
Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress .
Damaged plug and cord may result in electric shock or fire.
Disconnect the power supply by pulling the plug rather than
the cord . Do not operate power supply with damaged cord or
plug; have them replaced immediately . Damaged plug or cord
may result in electric shock or fire.
Do not insert battery pack in power supply if battery pack case
is cracked . Using damaged battery pack may result in electric
shock or fire.
Before each use, check the power supply, cable and plug . If
damage is detected, do not use the power supply . Never open
the power supply yourself, take it to a Skil Factory Service
Center, or qualified serviceman only using original spare parts.
Incorrect reassembly may result in electric shock or fire.
Unplug power supply from outlet before storage, attempting
any maintenance or cleaning . Such preventive safety measures
reduce the risk of electric shock or fire.
9