Publicidad
Idiomas disponibles
Idiomas disponibles
Install and Remove Bits
Your tool is equipped with a
magnetic bit holder, making bit
installation and removal very
convenient (Fig. 7).
Lock the trigger switch "OFF" by
placing the direction-of-rotation
selector in the center position.
a) To install the bit:
Insert the bit into the holder.
The integrated magnet will help to securely hold the bit in place.
b) To remove the bit:
Just pull the bit out of the holder.
WARNING
cool down . The bit may be hot after prolonged use .
Screw Driving
a) Install a suitable bit.
NOTICE: Always use the correct
type and size of screwdriver bit for
your application.
b) To tighten a screw, set
the direction of rotation at
"Forward".
c) To loosen a screw, set
the direction of rotation at
"Reverse".
d) Grasping only the handle of the tool, align the bit perpendicular to
the screw (Fig.8).
e) Apply just enough pressure to keep the bit engaged on the screw
and depress the trigger switch to begin screw driving.
24
Use protective gloves when removing the
bit from the tool, or first allow the bit to
Fig. 7
Fig. 8
Publicidad
