Publicidad
Idiomas disponibles
Idiomas disponibles
2.2 Temperature control panel
Recommended
gear
POWER
(The above pictures are for reference only, and the actual configuration shall be subject to the actual
purchase or the seller's statement)
2.3 Placement
2.4 Changing the light (optional)
The LED light must be replaced by a professional from the manufacturer, its maintenance
department or other similar departments.
(The above are for reference only, and the actual configuration shall be subject to the actual purchase
or the seller's statement)
●
Recommended
gear
●
"COOLING"
frozen area;
●
the temperature inside the freezer decreases;
●
counterclockwise, the temperature inside the freezer
increases;
●
"recommended
● Before
using
please remove all the
package, which includes
the base pad, the foam
cushion block in the
freezer and adhesive
tape, etc. And tear off
the protective film on the
door body and case.
● Select
the
far away from the heat
source and direct
sunlight Do not place it
in damp or watery areas
to prevent rusting or
weakening the insulation
effect.
After
The
is
When
When
Please
gear".
the
freezer,
place
that
is
18
power
on
area
where
the
refrigeration
the
temperature
the
temperature
refer
to
● Place
the
well-ventilated indoor
area with a flat and
sturdy ground.
●
The
should be greater than 70cm
and the distance between the
sides and back of the freezer
and the wall should be greater
than 20cm, so as to facilitate the
opening and closing of the
freezer door and heat dissipation.
the
"POW
the
tempe
area
contro
contro
the
schem
freezer
in
top
Publicidad
