Cuff Tube Connection; Select The User; Setting The Medication Reminder - Microlife BP3MQ1 Manual De Instrucciones

scroll back so scroll slowly so you don't miss the correct year. If you do pass the correct year
the unit will scroll all the way to 2050, then start again at the year 2000. Once you select the
correct year, press the Time/Date button to set it and move on to set the correct month.
Then the Month will begin flashing. Again, use the M (Memory button) to select the correct
month and press the Time/Date button to set it and move on to the day setting.
After you set the month, the Day will begin flashing. Again, use the M (Memory button) to
select the correct day and press the Time/Date button to set it and move on to the hour set-
ting.
After you set the day, the Time hour will begin flashing. Again, use the M (Memory button) to
select the correct hour according to AM or PM and press the Time/Date button to set it and
move on to the minutes.
The last setting is the Time Minutes. The minutes will be flashing. Again, use the M (Memory
button) to select the correct minutes and press the Time/Date button to set it and complete
your setting.
Please NOTE: You can cancel out of setting the User/Time/Date by pressing the Start/Stop
button. If no operation occurs during the User/Time/Date setting process, the unit will auto-
matically cancel out of it. To re-initiate the setting process, press and hold the Time/Date but-
ton for three seconds until the User icon begins flashing. Start the procedure all over again or
press the Time/Date button again and again until you reach the desired location to reset.

4.4. Cuff tube connection

Insert the cuff tube into the opening on the left side of the monitor indicat-
ed by a drawing of the cuff (see drawing at right).

4.5. Select the User

This blood pressure monitor is designed to store 99 measurements for each of two users.
Before taking a measurement, be certain that the correct user has been selected.
a) With the unit off, press and hold the Time/Date button for 3 seconds until the user icon
in the upper left corner of the LCD screen flashes.
b) Press the Memory button to toggle between users.
c) Press the START/STOP button to make your selection.

4.6. Setting the medication reminder

This instrument allows you to set two alarm times at which an alarm signal will then be trig-
gered. This can be a useful aid, for instance as a reminder to take medication or to remind
you to take your blood pressure at the same time each day.
9