Inserting Bobbin - Sears Kenmore 385.15108200 Manual De Instrucciones

o
Inserting bobbin
[_ Place a bobbin in the bobbin case, making sure the
thread feeds clockwise from the bobbin..
[] Draw the thread through the slot of the case.
[]Continue to draw the thread under the tension spring 0
and through the opening°
Pull out about 4" (10 cm) of thread°
(_ Tension spring
[] Holding the latch open, position the bobbin case into the
shuttle, and then release the latch.
[_The case should lock into the place when the latch is
released°
[]
.J
[
%
J
[]
22