Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
To reinstall the door
Warming drawer
50 English
1. Firmly grasp both sides of the door at
the top.
2. With the door set at the same angle as
the removal position (about 5 degrees
from vertical), slide the hinge arms into
the hinge slots at the bottom of the
door.
3. Open the door fully. If you cannot open
the door fully, the hinge arms are not
properly in the hinge slots.
4. Lock the hinge arms by pushing them
up against the front frame of the oven.
5. Close the door, and make sure it opens
and closes normally.
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Take the drawer by both hands.
Pull down the left clip while lifting up
the right clip to remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4. Put the drawer in the roller guides on
either side, and then snap the clips into
place.
Publicidad
