Generac 8kW Manual Del Usario página 17

ACTIVATION CHART
CHOOSE LANGUAGE
Display Reads:
Language
- English
Escape
Display Reads:
Activate me (ENT) or
ESC to run in manual
Escape
Display Reads:
To Activate go to
www.activategen.com
Escape
ENTER ACTIVATION CODE (Passcode)
Display Reads:
Serial 123456789
Passcode XXXXX +/-
Escape
Display Reads:
"SELECT HOUR (0-23)"
"- 6
Escape
Use ARROW keys to scroll to desired lan-
guage. Press ENTER to select.
+
Enter
Press ENTER to begin the activation pro-
cess.
Enter
If you do not have your activation code,
go to www.activategen.com or call
1-888-9ACTIVATE (922-8482).
If you already have your activation code,
wait 3-5 seconds for the next display.
Enter
Use ARROW keys to scroll and find the first
number of your Activation Code.
Press ENTER to select.
Repeat this step until all digits have been
entered.
Enter
Use ESCAPE to correct previous digits.
Activation is complete when all digits are
entered above and your screen shows this
display.
Follow the controller prompts to continue
+"
setting the time function. Refer to your
Owner's Manual with questions.
Enter
Post Installation Start-up and Adjustments
TROUBLESHOOTING
If the wrong language is chosen, it can be
changed later using the "edit" menu.
If ESCAPE is pressed instead of ENTER,
your generator will only run in manual mode
(for test purposes) and NOT ACTIVATED will
be displayed. You will need to remove the
generator control panel fuse AND disconnect
the T1, N1 and N2 connector in the external
connection box (if equipped); or disconnect
utility input (main breaker) to the transfer
switch for 3-5 seconds and reconnect, then
begin with Step 1.
TROUBLESHOOTING
What happens if "Wrong Passcode Try
Again" appears?
Reenter the activation code. If a second
attempt is unsuccessful, check the number
against the code given on activategen.com.
If it is correct and the generator will not
accept it, contact 1-888-9ACTIVATE (922-
8482).
15