Safety And Warranty - Rega Planar 6 Manual De Instrucciones

Safety and warranty

Safety instructions
Do not use this unit near liquids or expose to moisture.
Do not use near sources of heat such as radiators, vents, stoves, or
candles.
Ensure adequate ventilation around the product, at least 10cm in all
directions, and avoid placing the unit on soft surfaces such as long
carpet and fabric.
Do not open the product enclosure or force objects into openings in
the unit.
Place the unit on a fixed level surface where it will not fall or tip.
The unit should only be used in moderate climates between 5
degrees.
Celsius (41 degrees Fahrenheit) and 35 degrees Celsius (95 degrees
Fahrenheit).
Keep packaging material and small pieces out of reach of children.
Power input 24V AC 350mA. Power consumption 7.2W. Unplug the
power supply if the unit is unused for extended periods of time.
Service
With the unit disconnected from the mains, only clean with a micro
fibre cloth, (lightly damp if necessary). If the unit performs erratically
or emits smoke or odour, disconnect from the power supply and
take it to a qualified service technician.
Warranty
All Rega products are covered by a lifetime warranty against
manufacture defects. This warranty does not cover wear and tear.
Any unauthorised modifications or failure to follow the Rega
recommended guidelines may invalidate the warranty.
If returning goods for inspection to your retailer, the original
packaging must be used to preserve warranty. Replacement
packaging is available from any Rega retailer.
Your statutory rights are not affected.
6
Neo specifications
Output to motor bi-phase = 24V AC protected by resettable fuse.
Power consumption = 7.2 Watts.
Voltage = 24V AC. Rega PSU1 only.
Speed control step size = 0.01 RPM.
Stroboscopic disc = 100Hz, 180 marks 33.33 RPM. The basic one bar
per minute drift resolution = 0.016%.
Warnings
- Do not unplug the power supply from the turntable whilst the unit
is on - turn off the power supply before unplugging.
- Do not operate the power supply without the turntable connected.
- A 24V AC plus a 20V DC signal present on the pins of the plug - if
these are shorted it will cause damage to the power unit.
- Use only with the Rega PS1 power supply or Neo.
- Never expose the unit to rain or moisture.
- Do not open the case covers. There are no user serviceable parts
inside.
The Neo incorporates resettable fuses in the driver amplifier to
protect it from overcurrent faults, which will cause the turntable
to run erratically or not at all. If in the rare circumstance these are
activated, they are reset by turning off the Neo via the front panel
for approximately 10 seconds. If the fault should persist consult your
dealer.
Neo power supply specifications
PS1 (UK)
Input 230V ~ 50Hz 0.07A
Output 24V ~ 350mA AC
PS1 (EU - Euro 2 pin)
Input 230V ~ 50Hz 0.07A
Output 24V ~ 350mA AC
PS1 (UL - American)
Input 115-120V ~ 60Hz