Publicidad
Step 13
å
Push two RUBBER SLEEVES (2R) over the posts of the
PIVOT HINGES (15H).
å
Fasten two PIVOT HINGES (15H) to the TOP MOLDING (K).
Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Fasten six METAL BRACKETS (4G) to the TOP MOLDING (K).
Use six BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Be sure the BRACKETS are even with the edge of the
TOP MOLDING.
www.sauder.com/service
4G
K
These two holes must be
closer to the front edge.
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
15H
2R
422983
18
1S
4G
Page 17
Publicidad
