Publicidad
Step 19
å
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw
is against the stops as shown in the right diagram. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw.
å
Fasten a DOOR (U) to the LEFT UPRIGHT (E) as shown in the lower
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
å
Fasten a KNOB SET (167K) to the DOOR (U). Use a BLACK 1-1/8"
MACHINE SCREW (21S).
å
Repeat this step for the other DOOR.
å
See the next step for DOOR adjustments.
167K
www.sauder.com/service
U
E
21S
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOB SETS)
422983
17
Stop
Mounting
screw
Hinge
Page 23
Publicidad
