Publicidad
Step 16
å
NOTE: You will need a Tape Measure in this step. Each back will use six NAILS in this step.
å
Unfold the BACKS (P) and lay them into the lower edges of the ENDS (A and B) as shown in diagrams #1 and #2.
å
Fasten the BACKS (P) to the BRACE (F) and VERTICAL BRACE (N). Use eight CLIPS (67G) and eight BLACK 9/16"
LARGE HEAD SCREWS (1S).
å
NOTE: The CLIPS should wrap around the edges of the BACKS and the teeth of the CLIPS should bite into the BRACES
as you tighten the screws. Follow diagrams #3 and #4
å
Fasten the remaining edges of the BACKS (P) to the ENDS (A and B) and BOTTOM (C) using the Nail Holder and
NAILS (1N). The NAILS along the short edge of the BACKS (P) should be placed 1" from the fold line and approximately
2" from the corners. The NAILS along the long edge of the BACKS should be placed approximately 7" from the corners.
Bead
Lower edge
1.
1"
A
NAIL
(12 used in this step)
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Page 20
7"
P
F
1N
4.
67G
1S
Offset edge
67G
C
N
Lower edge
2.
422983
3.
67G
P
7"
B
1"
Offset edge
Bead
www.sauder.com/service
Publicidad
