Publicidad
Step 14
å
Fasten the TOP MOLDING (K) to the TOP (T2). Use six
BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Start each screw a few turns before tightening
any of them.
The posts on the PIVOT
HINGES should be pointing up.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Page 18
1S
Do not lift on the BRACE (F) until the
BACKS are fastened.
T2
K
422983
Side Step: Make
nachos. (Optional, but
recommended.)
Caution
F
www.sauder.com/service
Publicidad
