Publicidad
Step 26
å
Place your unit in its final location against the wall. We recommend using the SAFETY STRAP for added stability.
å
Open the FURNITURE TIPPING RESTRAINT KIT (97).
å
Fasten one end of the SAFETY STRAP to the TOP (T2). Use the short screw provided.
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY
STRAP to a wall stud, go to your local hardware store for proper hardware.
å
INSTALLATION INSTRUCTIONS:
1. Insert the SAFETY DRYWALL ANCHOR through the WASHER and the end of the SAFETY STRAP.
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall just below the top surface of your
unit so the SAFETY STRAP will not be visible.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is flush against the wall and you feel a firm resistance.
5. Continue to turn until the screw starts spinning freely.
å
NOTE: Before moving your unit to a different location, unscrew the SAFETY DRYWALL ANCHOR from your wall. The
nylon sheath will remain behind your wall.
Warning
For safety purposes, the hutch
must be placed against a wall.
www.sauder.com/service
Short screw
T2
422983
Washer
Safety strap
97
Safety
drywall
anchor
Page 31
Publicidad
