Publicidad
Step 27
å
Fasten a SHELF MOLDING (M) to a SHELF (I) as shown to the right. Tighten
two HIDDEN CAMS.
å
Repeat fastening the remaining SHELF MOLDING (M) to the
remaining SHELF (I).
å
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the
METAL PINS into the hole locations of your choice in the ENDS (A and B)
and UPRIGHTS (D and E). Set the ADJUSTABLE SHELVES (I) onto the
METAL PINS.
å
Using your hammer, gently tap a CAM COVER (12P) onto each visible
HIDDEN CAM.
å
NOTE: Please read the back pages of the instruction booklet for important
safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
1R
(8 used)
2R
12P
(12 used)
To cover HIDDEN CAMS
Page 32
B
I
422983
The holes in the MOLDING
should be closer to this edge.
Maximum
210 degrees
Minimum
190 degrees
E
D
I
A
1
M
I
Arrow
www.sauder.com/service
Publicidad
