Publicidad
Idiomas disponibles
Idiomas disponibles
location for an extended pe-
riod of time.
- Do not use in the presence of
an explosive atmosphere.
- Heat can be passed to flam-
mable materials that are hid-
den.
- After using the device, put
it on the stand and allow
it to cool down before it is
packed away.
- Do not leave the device un-
attended as long as it is in
operation.
• If in danger, immediately remove
the mains plug from the socket.
• Never use the device as a hair
dryer.
• Never direct the hot air flow at
people or animals.
• Do not look directly into the
nozzle opening on the blow-off
pipe.
• Do not touch the nozzle when it
is hot.
• Maintain distance between the
nozzle outlet and the surface or
workpiece you are working on.
The device could overheat.
Use as a solid fuel lighter / use
of the grill lighter nozzle (7)
• Check that the solid fuel lighter
is in the correct position.
• Isolate from the mains before re-
moving it from the fire.
• Allow the solid fuel lighter to cool
down before packing it away.
• The connection cable or other
flammable materials must not
come into contact with the hot
parts of the solid fuel lighter.
Caution: This is how to avoid
accidents and injuries by an
electric shock:
Electrical safety
• Make sure that the mains voltage
matches the details on the type
plate.
• Connect the device only to a
socket with a residual current
circuit breaker (Residual Current
Device) with a tripping current of
not more than 30 mA.
• Do not use the mains cable to
pull the plug from the socket. Pro-
tect the mains cable from heat,
oil and sharp edges.
• Switch the device off and pull
the mains plug out of the socket
if the mains cable is damaged.
If the connection cable of this
device is damaged, it must be
replaced by the manufacturer
or their customer service or by
a similarly qualified person in
order to avoid hazards.
• Do not connect a damaged
mains cable to the power supply.
Do not touch a damaged mains
cable as long as it is connected
to the power supply. A damaged
mains cable can result in voltage-
carrying parts being touched.
Initial start-up
When used for the first time, some smoke
may escape. The smoke is caused by bind-
ers which are removed from the insulating
film of the heater by the heat during first
use. To ensure that the smoke escapes
quickly, the device should be placed on
the stand area. Be sure to ventilate the
GB
MT
17
Publicidad
