Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
working environment during first use.
If the smoke/odour is too strong, move the
initial start-up to outside!
Operation
Switching ON and OFF
The device has a step switch (5) which
turns the device on and off. The step switch
(5) can also be used to pre-set the tempe-
rature.
Position "0": the device is switched off
Position "I": the device is switched on, the
temperature is 50 degrees
Position "II": the device is switched on, the
temperature can be adjusted to between 50
and 650 degrees via the control panel (4).
To switch off, turn the step switch (5) to
position "0".
The unit appliance a cool-down
function. To cool down, the fan
continues to run after it has been switched
off if you leave the appliance plugged into
the socket.
To do this, place the appliance on a level
and heat-resistant surface.
You can end the process by pressing the
"COOLDOWN" button.
Controlling the air volume
and temperature
The air volume and temperature can be con-
trolled via the control panel (4). The selected
setting is shown in the LCD display (3).
18
Temperature setting
To control the temperature, the step switch
(5) must be at position "II". The left and
right buttons on the control panel (4, see
next figure also) can be used to set the tem-
perature at 10 degree intervals.
Increase temperature.
Reduce temperature.
LCD display
-
displays the selected temperature
-
displays the current temperature
LCD lights up red =
LCD lights up green = Pre-set temperature
LCD flashing blue = cool down function
The device has a memory function.
The LCD display shows the last set tempe-
rature and saves it.
Setting the air volume
The air volume can be adjusted to between
150 and 500 l per minute. This is possible
from both position "I" and position "II" of
the step switch (5).
Increase air volume.
Reduce air volume.
Pre-heating phase
reached
Publicidad
