Angelcare AC201 Manual Del Propietário página 7

7) Do NOT attempt to recharge batteries provided
with or identified for use with this product that are not
intended to be charged. The batteries may leak cor-
rosive electrolyte or explode.
8) Do NOT attempt to rejuvenate the batteries with or
identified for use with this product by heating them.
Sudden release of battery electrolyte may occur,
causing burns or irritation to eyes or skin.
9) If and when necessary, the batteries must be
replaced with identical new ones or equivalent (volts
and size). If a battery to be replaced is connected
with other batteries in series, replace the other bat-
teries at the same time as well. Do NOT mix old and
new batteries.
10) Reverse polarity installation of the batteries in
the end product must be avoided. Reverse insertion
of batteries can cause charging, and that may result
in leakage or explosion.
11) Remove batteries from this product if you store
the product over 30 days because the batteries could
leak and damage the product.
12) Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
13) Do NOT store this product, or the batteries pro-
vided with or identified for use with this product, in
high-temperature areas. Batteries that are stored in
a freezer or refrigerator for the purpose of extending
shelf life should be protected from condensation dur-
ing storage and defrosting. Batteries should be stabi-
lized at room temperature prior to use after cold stor-
age.
COMPLIANCE INFORMATION
WARNING
Modifications not authorized by the
manufacturer may void users authority to
operate this device.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential installa-
tion. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
7