Medion LIFE E14080 Manual De Operación página 163

– FAV
In order to save a channel to the favourites list,
select it and press the F A V button. You can
call up the favourites list via the buttons on
the remote control.
SIGNAL INFORMATION
The signal information about the currently set channel will
be displayed here.
This option is only available in DTV/satellite mode.
CI INFORMATION (CI+)
If you want to watch subscription channels, you must first
register with the relevant provider. You will receive a Con-
ditional Access Module (CA module) and a special card
from your provider after registration. You will find infor-
mation about the settings in the documentation supplied
with the module.
Install the CI components on your television in the follow-
ing way:
 Switch the television off and pull out the mains plug.
 First insert the CI module in the slot on the side of the
LCD TV. Then insert the card.
Please note that you may only insert or remo-
ve the CI module when the device has been
disconnected from the mains electricity net-
work.
PLEASE NOTE!
Risk of damage!
The CI module or the television could
be damaged if you attempt to insert
the CI module by force.
 The CI module must be inserted
correctly: it cannot be inserted if it
is the wrong way round.
 Connect the television to the power supply, switch it
on, and wait for a moment until the card is recognised.
 Additional setup steps may be required for some CAM
modules, which you can complete in the CI INFOR
MATION menu.
DISH SETUP
(only DVB-S)
– SATELLITE
Select the satellite for which you want to
change the settings or carry out a search.
EDIT
Press the green button to edit the selected
satellite.
You can change the name of
the satellite with the help of
the displayed keyboard. Use
SATELLITE the arrow buttons to select the
NAME
desired characters and confirm
them with the O K button.
Save the new name with the
blue button.
LONGI Use the direction buttons 
TUDE DI
to select the orbit position
RECTION WEST or EAST.
LONGI
The number buttons can be
TUDE
used to enter the angle.
ANGLE
Select the desired frequency
BAND
band KU or C.
ADD
Press the yellow button to add a new satellite.
The setting options are the same here as un-
der EDIT.
DELETE
Select the satellite that you want to delete
from the list and press the red button. Confirm
the query with YES.
SCAN
Press the blue button to make the settings for
the search.
Set the search mode.
DEFAULT: A search will be car-
ried out on the selected satel-
lite, based on the transponder
list saved for this satellite. This
requires a little time.
NETWORK: Activate/deacti-
vate the network scan.
BLIND SCAN: A complete
search will be carried out on
SCAN
the selected satellite. This will
MODE
also take into account new
transponders that have not
been added to the list of tran-
sponders. Two searches are
carried out with the blind scan.
The first search identifies the
transponders for the satellite,
while the second search locates
the channels. The blind scan
takes the longest time.
Decide which channels you
want to search for: FREE (free
CHANNEL channels), SCRAMBLED
TYPE
(encrypted channels) or
FREE+SCRAMBLED (free and
encrypted channels).
Select the channel type.
DTV: Search for digital TV chan-
nels.
SERVICE
RADIO: Search for digital radio
TYPE
stations.
ALL: Search for digital TV chan-
nels and digital radio stations.
When you have finished entering all your set-
tings, press the O K button. The search on the
desired satellite will now start.
EN
19