Publicidad
Idiomas disponibles
Idiomas disponibles
6. Gett ing started
.
Before using for the first time, ensure you read
the "Safety instructions" section.
6.1. Unpacking
•
Select a suitable place for setting up the device before
unpacking.
•
Open the box very carefully, to avoid damaging the
device. The device might get damaged if you use a
knife with a long blade to open the box.
•
The box contains a number of small items (including
batteries). Keep these out of the reach of children, as
they represent a choking hazard.
•
Store the packaging material in a safe place. Only use
this box to transport the TV.
DANGER!
Risk of choking and suffocation!
Packaging film can be swallowed or
used improperly, creating a risk of
choking and suffocation.
Keep packaging material such as
plastic film or plastic bags away
from children.
6.2. Mounting
Attach the feet as shown in the illustration. Carry out this
step before connecting the Smart TV.
6.3. Inserting batt eries in the re-
mote control
Remove the battery compartment cover on the back
of the remote control.
Insert two LR03 (AAA) 1.5 V batteries in the battery
compartment of the remote control. Check the battery
polarity (see label on the bottom of the battery com-
partment).
Close the battery compartment.
6.4. Connecting the antenna
Your smart TV supports different antenna signals.
You can input the following image signals to the television
through the socket labelled ANT.:
•
Via analogue cable/an analogue house aerial
•
Via a DVB-T2/ DVB-T
•
Via a DVB-C
Insert the antenna cable either from the house aerial/
analogue cable connection, a DVB-T antenna or the
DVB-C connection in the antenna socket on the Smart
TV.
You also have the option of connecting a digital satellite
system to the socket labelled LNB.
Screw a coaxial antenna cable's F connector onto the
connector on the Smart TV.
6.5. Connecting the power supply
Connect the supplied power cord to the mains con-
nection socket of the device.
Connect the mains plug on the device to an easily ac-
cessible 220 to 240 V ~ 50 Hz mains socket.
6.6. Switching the Smart TV on and
2 x M5x20
The device will be in standby mode as soon as you
have connected the mains plug to the mains socket.
To switch on the device, press
– on the remote control: the standby/on button, one
of the number buttons or one of the P / but-
tons;
– on the device: the switch
Use the standby/on button on the remote control to
switch the device back into standby mode. The device
will be switched off, but will continue to use power.
1
This service must be available in your region.
NOTICE!
Risk of damage!
The remote control can be damaged
by leaking batteries if not used for a
long period of time!
Remove the batteries from the re-
mote control if the device is not go-
ing to be used for a long period.
1
antenna or
2
connection (digital cable connection)
To receive encrypted/subscription channels
you will need to use a CI module (Conditional
Access Module) and an appropriate card. In-
sert a CI module (available in specialist shops)
in the slot provided for this purpose on the
left-hand side of the device (COMMON IN-
TERFACE). You can then insert your provider's
card in the CI module.
off
.
EN
11
Publicidad
