SHOP
TYPE
LNB CON
FIGURA
TIONS
TRAN
SPONDER
SIGNAL
QUALITY
SIGNAL
LEVEL
SINGLE
TONE
BURST
DISEQC
.
DISEQC .
DISEQC
.
UNICA
BLE I
UNICABLE
II
SATELLITE ADD
Select this option to add a satellite. The setting
options are the same here as under SATELLITE
RESCAN.
22
Select the desired storage
type.
LNB
Set the LNB
POWER
power here.
Set the desired
LNB FRE
LNB frequency
QUENCY
here.
Set the sound
here. The de-
TONE
fault setting
KHZ
is AUTOMA
TISCH.
SIGNAL
Displays the
QUALITY
signal quality.
SIGNAL
Displays the
LEVEL
signal level.
Select the desired frequency,
symbol rate and polarisation
for the transponder here.
Displays the signal quality
Displays the signal level
MORE
Select the required satellite
here.
If your satellite system re-
quires a tone burst, you can
set it to TONE BURST A or
B here.
If you have connected multi-
ple LNBs or a DiSEqC switch
to your satellite antenna,
select DiSEqC 1.0 here.
If you have connected multi-
ple LNBs or a DiSEqC switch
to your satellite antenna,
select DiSEqC 1.1 here.
If you have connected multi-
ple LNBs or a DiSEqC switch
to your satellite antenna,
select DiSEqC 1.2 here.
Select the Unicable I settings
(TUNER and BAND FRE
QUENCY) here.
Select the Unicable II set-
tings (TUNER and BAND
FREQUENCY) here.
SATELLITE UPDATE
Update the satellite by repeating the previ-
ous scan with the same settings. You can also
change these settings before the search. The
setting options are the same here as under
SATELLITE RESCAN.
SATELLITE MANUAL TUNING
Use this option to start a manual satellite
search.
CHANNEL SKIP
Set channels to be skipped when switching
the channels on the remove control. Highlight
the desired channels in the list and press O K
to select or deselect them.
CHANNEL SWAP
Open the channel change list here.
This option takes you to the
programme at the top of the
PAGE UP
displayed page. When this
(red but-
button is pressed again, you
ton)
move up through the chan-
nel list in steps of 11.
This option takes you to the
PAGE
programme at the bottom
DOWN
of the displayed page. When
(green but-
this button is pressed again,
ton)
you move down through the
channel list in steps of 11.
GO TO
Enter the channel number
CHANNEL
that you wish to call up into
(yellow
the text field.
button)
EXIT
Close the channel change
(blue but-
list.
ton)
CHANNEL MOVE
Move a channel to the position of another
channel. Highlight the channel you want to
move and press OK to select. Highlight the
second channel in the same way. When the
second channel is selected, the first selected
channel is moved to the position of that chan-
nel.
CHANNEL EDIT
Here you can edit channels in the channel
list. Edit the name and channel number of
the selected channel and, if available, display
information on the network name, frequency,
colour system and sound system for this chan-
nel. Other options can also be edited depend-
ing on the channel. Press the blue button to
delete the highlighted channel.
CHANNEL DELETE
You can delete individual channels here.