YATO YT-55841 Manual página 13

PRODUCT OVERVIEW
Sandblast cabinet is a sandblasting unit. Sandblasting is the mechanical removal of rust and/or paint coatings from objects using
a jet of abrasive material (abrasive) ejected from the gun nozzle by means of a jet of compressed air. Since sandblasting takes
place inside the sealed chamber, dusting of the abrasive material is reduced to minimum. The correct, reliable, and safe operation
of the appliance depends on its proper use, therefore:
Read the entire manual before the fi rst use of the tool and keep it for future reference.
The supplier is not liable for any damage resulting from failure to observe the safety instructions and recommendations contained
in this manual.
EQUIPMENT
The unit is delivered disassembled and must be assembled according to the instructions provided below before starting work.
The product is delivered with a blast gun, additional nozzles and a pair of protective gloves. Abrasive is not supplied with the tool.
TECHNICAL DATA
Parameter
Part No.
Maximum pressure
Operating pressure
Air consumption
Outer dimensions
Working area dimensions
Cabinet working capacity
Maximum abrasive volume
Weight (without abrasive)
Noise level
- sound pressure L
pA
Vibration level a
h
Lamp
Rated voltage
Rated power
Lamp power supply
Supply voltage
Rated frequency
Output voltage
Output current
SAFETY INSTRUCTIONS
Warning! Close and secure the door before starting work. Unsecured doors can cause serious injuries.
Warning! Disconnect the machine from the air and power supply before opening the lid and before performing any maintenance
works.
The abrasive and compressed air jets are potentially hazardous. Never point the tool outlet towards people - abrasives or com-
pressed air can cause body trauma or other injuries. Injection of lubricant can cause necrosis or even loss of limb. In case of
injection, seek medical attention immediately.
Due to multiple hazards, read and understand the safety instructions before starting the installation, works, repair, maintenance,
and changing the accessories or when working in the vicinity of a pneumatic tool. Failure to do all of the above could result in
severe personal injury. Pneumatic tools may only be installed, adjusted, and assembled by qualifi ed and trained personnel. Do
not modify the pneumatic tool. Modifi cations can reduce effi ciency and safety, and increase the risk for the tool operator. Do not
throw away the safety instructions. They should be handed over to the tool operator. Do not use the pneumatic tool if it is damaged.
Operators and service personnel are required to receive appropriate training in the use and repair of the equipment.
It is forbidden to use any other gases instead of compressed air. The use of other gases may lead to serious injury, cause fi re or
explosion. When connecting the tool to the compressed air system, consider the space required for the hose to avoid damaging
the hose or connectors.
Eff ective ventilation should be provided at the workplace. Lack of eff ective ventilation may result in health hazards, cause fi re or
explosion. The tool is not intended for use in explosive atmospheres. Use the tool away from heat sources and fi re as this may
O R I G I N A L
EN
Unit
[MPa]
[MPa]
[l/min]
[mm]
[mm]
[l]
[l]
[kg]
[dB(A)]
[m/s 2 ]
[V DC]
[W]
[VAC]
[Hz]
[V DC]
[A]
I N S T R U C T I O N S
Value
YT-55841
0.82
0.27 – 0.82
424 – 707
1380 × 940 × 580
370-540 x 840 x 560
220
17
43
≤ 70
< 2.5
12
12
100 – 240
50 / 60
12
1
13