Taurus TC-350 Instrucciones De Uso página 6

EN English (Original instructions)
CITRUS JUICER
TC-350
TC-350 NERO
DESCRIPTION
A Motor base
B Pulp regulator filter
C Juice deposit
D Pulp filter
E Cone
F Supply cord housing
If the model of your appliance does not have the
accessories described above, they can also be bought
separately from the Technical Assistance Service.
USE AND CARE
• Fully extend the appliance's supply cord before each use.
• Do not use the appliance if the accessories attached to it
are defective. Replace them immediately.
• Do not move the appliance while in use.
• Do not use the appliance if it is tipped up and do not turn
it over.
• Do not turn the appliance over while it is in use or
connected to the mains.
• Respect the deposit MAX level. (350 ml). (Fig. 1)
• Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
• Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
INSTRUCTIONS FOR USE
BEFORE USE
• Make sure that all product's packaging has been
removed.
• Please read carefully the "Safety advice and warnings"
booklet before first use.
• Before using the product for the first time, clean the
parts that will come into contact with juice in the manner
described in the «Cleaning» section.
USE
• Extend the supply cord completely before plugging it in.
• Connect the appliance to the mains.
• Cut the citrus fruits to be squeezed in half.
• Turn on the appliance by pushing down on the piece of
citrus fruit, once it has been placed on the juicing cone.
• To avoid a fierce start up, the appliance is turned on
progressively.
• To stop the appliance, simply stop applying pressure to
the cone.
• Empty the juice deposit, pouring its contents into the
glass or container of your choice when it is finished.
• Remark: If you process a large quantity of fruit, you must
periodically clean the filter and remove the remains of
the pulp.
PULP REGULATOR
• This appliance has a system for regulating the quantity of
pulp filtered.
• The quantity of pulp can be regulated by turning the juice
deposit while holding the motor base.
• For maximum filtering, turn the juice deposit anticlockwise
until it stops. (Fig. 2A).
• For minimum filtering, turn the juice deposit clockwise
until it stops. (Fig. 2B).
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Unplug the appliance from the mains.
• Put the supply cord back in the supply cord housing.
• The supply cord housing means you can remove and
have available the required length of supply cord for
working with the appliance, preventing accident risk
situations.
• Clean the appliance.
SUPPLY CORD HOUSING
• This appliance has a supply cord housing situated on its
underside. (Fig. 3).