cecotec Bolero DressCode 9410 Inverter Steel A Manual De Instrucciones página 39

ENGLISH
2. Unscrew the plug and remove any foreign material or objects from the drain outlet. Be
careful with possible water that may come out during the process. Fig. 17
3. Refit the plug and close the cover. Fig. 18
Cleaning the water inlet valve filter
The inlet filter must be cleaned if no or insufficient water enters when the tap is opened.
1. Lower the water pressure:
a. Close the tap.
b. Select any programme except Spin.
c. Press the Start/Pause button and keep the programme running for about 40 seconds.
d. Disconnect the plug.
2. Disconnect the inlet hose from the tap. Fig. 19
3. Gently pull out the filter using a pair of needle-nosed pliers. Use extreme caution not to
force the filter to avoid damaging it. Fig. 20
4. Wash the filter with water and remove any accumulated dirt.
5. Place the filter back in its original position.
6. Reconnect the inlet hose. Fig. 21
Cleaning the detergent drawer
1. Open the detergent drawer (lift it up slowly) and remove the cover 1 (siphon plate) by
lifting it up as shown in figure 22.
2. Wash the detergent drawer and the siphon with tap water or clean them with a brush.
3. Refit the detergent drawer and the siphon.
- It's possible for some detergent to get into the drum when removing the detergent drawer.
This is normal.
- To avoid spillage, make sure that no water, detergent, or softener is left in the detergent
drawer before removing it.
Defrost
Do not expose the washing machine to temperatures below 0 °C, as this may affect its operation
and the lifespan of its parts. Should you notice frozen parts, follow the below procedure:
Turn off the washing machine and unplug the power cord.
1.
Pour hot water over the tap to loosen the water inlet hose.
2.
Disconnect the water inlet hose and immerse it in hot water.
3.
Pour hot water into the drum and leave it for about 10 minutes.
4.
Reconnect the water inlet hose to the tap.
5.
Please note
1. When resuming use of the washing machine, make sure that the ambient temperature is
above 0 °C.
2. If the washing machine is located in a room where it can easily freeze, thoroughly drain
76
Bolero Dresscode 7410 Inverter A / Bolero DressCode 7410 Inverter Steel A
Bolero Dresscode 8410 Inverter A/ Bolero DressCode 8410 Inverter Steel A
Bolero Dresscode 9410 Inverter A/ Bolero DressCode 9410 Inverter Steel A
Bolero Dresscode 10410 Inverter A/ Bolero DressCode 10410 Inverter Steel A
the remaining water inside the drain hose and water inlet hose.
3. Refer to a technician if the washing machine freezes. If the washing machine still does
not work after the above procedure, please contact the official Cecotec Technical Support
Service.
6. TROUBLESHOOTING
PROBLEMS POSSIBLE SOLUTIONS
There's water in the drum This is normal. It's the result of factory water tests.
before first use.
The washing machine does Check that the plug is properly connected to the socket.
not turn on. Check if the tap is open.
Check if the Power button was pressed.
Check if the Start/Pause button was pressed.
Check if the Delay Start function is enabled.
The washing machine leaks. Check and tighten the water inlet hose.
Clean the drain hose and contact the official Cecotec
Technical Support Service.
Strange noise and strong Check whether the transport bolts have been removed.
vibrations. Check if the levelling feet are properly adjusted. Check if the
washing machine is installed on a level and solid surface.
Check for metal items inside.
Washing results are not Select a suitable washing programme.
satisfactory. Add the appropriate amount of detergent according to the
instructions on the detergent package.
The buttons do not work. Check whether the "Child Lock" function is enabled.
The actual running time Check if the laundry in the drum is evenly spread out.
of the programmes does Check if the water flows in and out properly.
not correspond to the time
indicated on the display.
The washing machine fills up Check if the height of the drain hose is less than 65 cm.
during draining. Check if the drain hose is submerged.
Bolero Dresscode 7410 Inverter A / Bolero DressCode 7410 Inverter Steel A
Bolero Dresscode 8410 Inverter A/ Bolero DressCode 8410 Inverter Steel A
Bolero Dresscode 9410 Inverter A/ Bolero DressCode 9410 Inverter Steel A
Bolero Dresscode 10410 Inverter A/ Bolero DressCode 10410 Inverter Steel A
ENGLISH
77