Publicidad
Idiomas disponibles
Idiomas disponibles
Using Timer
The TV can automatically turn On/Off at the designated date and time.
•
The Clock must be set before On time/Off time settings. (p. 13)
1
Display menu
2
Select "Timer"
Menu
Picture
Audio
Timer
Lock
Memory card
TVG/Photo
Setup
3
Select the timer to set
-
Timer
Sleep
Timer 1
Timer 2
Timer 3
Timer 4
Timer 5
4
Set the timer
■
To set "Sleep" (Off Timer)
Press to set unit to shut itself off after a preselected amount of time.
Sleep
■
Press to exit
Sleep
■
To set "Timer 1-5" (On/Off Timer)
Select the item and set
■
Press to return
to the previous
Timer 1
screen
CH
Day
On time
Off time
Note
•
Set
The TV automatically
turns Off after 90
minutes when turned
On by the Timer.
This operation will be
cancelled if the Off
time is selected or if a
key is pressed.
44
next
select
select
next
Sleep
Turns Off automatically
Turns On/Off automatically
Timer 1
(5 timers can be set.)
Timer 5
•
0/30/60/90 (minutes)
select
60
select
310 - 1
set
EVR FRI
10:00 AM
CH
Select the channel
11:00 AM
Day
Select the day
On
SUN/MON/TUE/WED/THU/FRI/SAT/
MON-FRI/SAT-SUN/DAILY/EVR SUN/
EVR MON/EVR TUE/EVR WED/EVR THU/
EVR FRI/ EVR SAT
On time
The time to turn On
The time to turn Off
Off time
Set
Timer setting (On/Off)
Operating Peripheral Equipment
You can operate other manufacturers' components using this TV's remote control.
1
Connect the external devices to the TV and
turn Off the external equipment
2
+
3
4
5
Caution
•
Registration will fail if the wrong code is input or it takes more than 30 seconds to register.
To find a code not listed in the code list
This procedure searches all codes and is called the "sequence method."
After step
above, change the code and
test
change
Operate the equipment with the
remote control (p. 48)
•
Repeat until the code is found
•
It may take many attempts before the correct
code is found
Press both buttons simultaneously
for more than 3 seconds.
•
Release the buttons when the equipment selection
buttons start flashing.
Select the equipment
with the equipment selection button
•
The selected button remains lit (other buttons are not
lit).
Input the equipment's 4-digit remote
control code
(p. 49-50)
Confirm the equipment with the
remote control
•
The external equipment turns On.
■
If the equipment does not operate with
remote control
•
When your equipment has a single code
Input the remote control code again
•
When your equipment has multiple codes
Change the code with
above and test again
(p. 49-50)
When the correct code is found
store
45
Publicidad
