Publicidad
Idiomas disponibles
Idiomas disponibles
INITIAL GUIDE SETUP for TV Guide
5
Configure Your VCR
If you want to use TV Guide On Screen Listings to schedule recordings to your
VCR, answer Yes, set up VCR control.
Additional screens ask you to
• Confirm remote control options
• Confirm the external connections.
• Select the VCR brand.
• Test and confirm the remote code.
If you do not want the Guide to control recording to your VCR, answer No, end
setup and go to Step 6.
6
Complete Setup
The Helpful Information screen is displayed when you successfully complete
Guide setup.
7
View Setup Progress Screen
The setup progress screen appears each time you enter the Guide prior
to receiving your initial eight days of show listings. To close the screen
press ◄ or [OK].
Caution
•
In order to begin to receive your listings, power Off the TV when not in use. Within 24 hours, you will begin to
receive TV show listings. It may take up to six days to receive the full eight days of initial show listings.
16
Watching TV
(Continued)
Insert the CableCARD™ when watching cable TV. (p. 11)
Note
•
Reselect "Cable" or
"Antenna" in "ANT
In" of "Auto program"
to switch the signal
reception between
cable TV and antenna.
(p. 14)
•
The channel number
and volume level
remain the same even
after the TV is turned
off.
1
Switch to TV mode
2
Turn power on
•
POWER button on
unit should be On.
3
Close TV Guide
- -
4
Select a channel number
up
or
down
■
To directly input the digital channel number
•
When tuning a digital channel, press the button to enter
-
the minor number in a compound channel number.
example: CH15-1:
To not display TV Guide when turning power On
Select "SETUP"
Select "Change default options" and press "OK" button
Select "General defaults" and press "OK" button
Select "auto guide" and set "off"
5
Select "done" and press "OK" button
6
TV Guide open up
-
select
17
Publicidad
