Publicidad
Idiomas disponibles
Idiomas disponibles
Safety and operating instructions
Start and stop
WARNING
Whipping discharge hose
A discharge hose that comes loose can lash around,
and the hose or jets of liquid can hit the operator,
and cause personal injury or death. To reduce this
risk:
Always remove kinks, before the pump is started.
►
If the discharge hose is kinked, it can be forced
out of the operator's hands.
Always make sure that the discharge hose
►
connections are properly attached.
Check that the discharge hose and the
►
connections are not damaged, replace if
necessary.
Always make sure that the outlet end of the
►
discharge hose is properly secured.
Start and stop
Start the pump by connecting it to the power source
and turning the start and stop device.
Stop the pump by turning the start and stop device
and disconnecting it from the power source.
12
Operating
>
The following must be performed at the start of
every shift:
>
Fill the reservoir with recommended oil.
>
Check the dosing functions, by holding a piece
of clean paper in front of the exhaust air outlet.
After about five seconds traces of oil should
appear on the paper. Adjust the oil dosing if
necessary; see section "Oiler adjustment".
>
Allowing liquid to freeze inside the pump can
cause damage to the pump.
>
Do not run the pump dry for longer periods,
doing so will cause damage to the seals.
>
If the pump has been used in corrosive or polluted
water, it must be operated in clean water for a
few minutes after use.
>
Always make sure that the venting hole (see
section "Main parts") is open.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
For major service to the machine, contact your
♦
nearest authorised workshop.
Every day
Before undertaking any maintenance on the pump,
always switch off the air supply. Then disconnect
the air hose from the machine.
♦
Clean and inspect the machine and its functions
each day before the work commences.
Conduct a general inspection for leaks and
♦
damage.
Check that the air inlet nipple is tightened and
♦
that the claw coupling is free from damage.
9800 1056 90a | Original instructions
CP 0020
Publicidad
