Descargar Imprimir esta página

Parkside PHD 135 D5 Traduccion Del Manual De Instrucciones Originale página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 110
GB
MT
• People who are not familiar with the instruc-
tion manual may not use the device.
• Pressure washers must not be operated by
untrained persons.
• In the case of a malfunction or defect dur-
ing operation, the device must be switched
off immediately and the mains plug un-
plugged. For possible causes of a malfunc-
tion: Troubleshooting, p. 25. Or, con-
tact our service centre.
• Note that the user is responsible for any ac-
cidents or risks to others and their property.
• Observe noise protection rules and other
local regulations.
Preparation
• Protect yourself against splashing water or
dirt by wearing protective goggles and suit-
able protective clothing.
• Do not work with a damaged or incomplete
device or one which has been converted
without the permission of the manufacturer.
Before commissioning, have a specialist
check that the required electrical protective
measures are in place.
• The device may only be connected to
a socket that was installed by an exper-
ienced electrician in accordance with
IEC 60364-1.
• Prior to use, always check the connecting
cable and extension cable for signs of dam-
age or wear and tear. If the cable gets
damaged during use, it must be disconnec-
ted from the supply network immediately.
DO NOT TOUCH THE CABLE BEFORE IT
HAS BEEN DISCONNECTED FROM THE
POWER SUPPLY. Do not use the device if
the cable is damaged or worn.
• If the mains connection cable of this device
is damaged, it must be replaced by the
manufacturer, their customer service or by a
similarly qualified person in order to avoid
hazards. Contact the Service Centre.
• Connect the device only to a power sock-
et with a residual current circuit breaker of
rated residual current no more than 30 mA.
20
• Unsuitable extension cables can be dan-
gerous! Use only extension cables that are
designed for outdoor use. The connection
must be dry and routed above the ground.
We recommend using a cable drum that
holds the socket at least 60 mm above the
ground.
• Extension cables must have a minimum wire
cross section of 2 × 2.5 mm².
• High-pressure hoses, fittings and couplings
are important for device safety. Only use
high-pressure hoses, fittings and couplings
recommended by the manufacturer.
• Do not start the device up if the mains con-
nection cable, water supply or other import-
ant parts such as the high-pressure hose or
spray gun are damaged or leaky.
• Only use the device standing and on a firm,
level surface.
• Never use the device if there are children or
animals nearby. People nearby must wear
protective clothing.
Operation
• Pay attention, be aware of what you are
doing and take the utmost care when work-
ing with the device. Do not use the device if
you are tired or you are under the influence
of drugs, alcohol or medication.
• High-pressure jets can be dangerous if used
incorrectly. The jet must not be directed at
persons, animals, active electrical equip-
ment or the device itself.
• Do not direct the jet at yourself or others to
clean clothing or shoes.
• If you come into contact with cleaning
agents, rinse them with sufficient clean wa-
ter.
• Never use the mains connection cable to
pull the plug out of the socket or to pull the
device. Protect the mains connection cable
from heat, oil and sharp edges.
• Risk of explosion – do not spray any flam-
mable liquids.
• Do not use the device near flammable li-
quids or gases. There is a risk of fire or ex-
plosion if this advice is not heeded.

Publicidad

loading