Publicidad
Idiomas disponibles
Idiomas disponibles
• protected against frost
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and accessories
will be destroyed by frost if they are not com-
pletely emptied of water.
1. Completely empty the water from the
device.
• Disconnect the device from the water
supply.
• Turn on the pressure washer with the
On/Off switch (2) for a maximum of 1
minute.
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not work
Device does not convey water
No pressure in device
2. Completely empty the water from the ac-
3. Store all attachments upright in the holders
4. Remove the high-pressure hose. Empty the
5. Store the high-pressure hose and mains con-
Possible cause
On/Off switch (2) turned off
No mains power supply
Incorrect voltage supply
Air locks in the pressure washer
Air locks in the pressure washer Bleeding, p. 23
Pressure loss in line
• Press the switch lever (13) on the trigger
gun (1) until there is no more water com-
ing out of the trigger gun (1) or the at-
tachments.
• Turn off the device.
cessories.
with the connection facing downwards.
high-pressure hose.
nection cable in the intended holders (5, 6).
Error correction
Check the position of the On/
Off switch
Check the socket, mains connec-
tion cable, plug and fuse and
have them repaired by a quali-
fied electrician if necessary.
Check whether the electrical sys-
tem matches the information on
the type plate
Turn the device on and press the
switch lever (13).
Bleeding, p. 23
Check the water supply
GB
MT
25
Publicidad
