Publicidad
Idiomas disponibles
Idiomas disponibles
For cutting of steel, non-ferrous metal, GRP,
pressed materials, resin bonded fabric,
Plexiglas and insulation material.
1
Allen key
STS/A (29857)
1
Cordless jig saw STS/A
1
Operating instructions
1
Safety guidelines
2
Jig saw blades of special steel, ground and
side set teeth (teeth division 1.5 mm). For
cutting all types of wood, fi breglass sheets
and soft plastics.
2
Jig saw blades of HS steel, ground and
wavy set teeth (teeth division 1.06 mm).
For cutting of steel, non-ferrous metal, GRP,
pressed materials, resin bonded fabric,
Plexiglas and insulation material.
1
Allen key
3 Technical data
Device:
Number of strokes:
Voltage:
Length:
Weight:
Noise generation:
General measuring
uncertainty:
Grip vibration:
Charger:
Mains voltage:
Output voltage:
- 12 -
max. 4500 rpm
10.8 V
approx. 245 mm
(with battery)
approx. 210 mm
(without battery)
approx. 935 g
(with battery)
approx. 755 g
(without battery)
LPA 87 dB(A)
LWA 100 dB(A)
K=3 dB
2
≤ 2.5 m/s
100-240 V~
50/60 Hz
12.6 V
Charging current:
Battery:
Rechargeable lithium-ion battery
Nominal/charging voltage: 10.8 V / 12.6 V
Energy/Capacity:
4 Noise/vibration information
The information on vibration and noise emissi-
on has been determined in compliance with the
prescribed standardised and normative measu-
ring methods and can be used to compare elec-
trical devices and tools with each other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Depending on the operating conditions, the
emissions that actually occur may deviate from
the values given above!
This applies in particular depending on the
workpiece to be machined and the insert tool
(especially its wear condition). Unsuitable
workpieces or materials, poorly maintained
tools, too high a feed rate or unsuitable insert
tools can signifi cantly increase the vibration
load and noise generation.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Observe the following instructions to minimise
vibration exposure:
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
2 A
28.2 Wh / 2.6 Ah
Publicidad
